After completing an end grain cutting board I wanted to try to make an edge grain cutting board. I had enough materials to make 2 boards but with the first board, mistakes were made. The router bit slipped causing a gauge to the juice groove, I also had the bit wander on the handle, and finally after applying the mineral oil I noticed the juice groove wasn’t centered on the board. Some days the cards just don’t fall in your direction. I have some solutions with some jigs to avoid these mistakes in the future and I’ll show them in an upcoming video so stay tuned. Until then I hope you enjoy watching this trainwreak of a project.
I have been doing woodworking since I was in high school (a while) and I also enjoy making 3D projects and general projects so the videos I post will be basically what projects I have going on and how I go about getting them done.
Post navigation
Previous Post
Why You Should Always Use a Push Stick When Woodworking